• 5 Answers SOURCE: I got it! You should see 'start goal' in the bottom right. Press the user # you want to save as and press 'set' again. The display will blink then display '0.0'. Step on the scale to get your current weight.

Software Kran Simulator 2009 German-0x0007. Once it's read you current weight, press 'set'. A goal weight will display. Press 'User 1' to make your goal weight go up and 'User 2' to make it go down. Press 'set' when the display shows your goal weight. Now all you have to do is press your user # and wait for '0.0' to display before stepping on the scale. Posted on Mar 26, 2010. Remove the battery and count to 10 and then replace it.

Are you looking for a Salter Scales instruction manual? All Salter Scales user manuals. 9114 Body Analyser. I have lost my salter 9114 bathroom scale instruction manual model number 9114 bathroom scales - Salter Health & Beauty question.

I found this You do not reset the scale. It only saves the last recorded weight of the user. So, if you weighed yesterday, it will put your recorded weight in memory. The next time you select your user number and step on the scale, it will compute the difference from your previous record and save your current weight. And also this I had the same problem with my Salter 987 scale. Pull the battery out for about 10 seconds and put it back in. Then push the scale once so it turns on. Asa Made Jugyou Chu Manga Volume 1.

After the blinking stops, push it once more. The scale will now zero itself. After the scale has zero'd itself it may turn off after a brief moment. It's now ready to use normally. If you're standing on the scale when it's trying to calibrate to zero, it will assume your weight is zero.

Don't stand on the scale after replacing the battery until you first complete the steps listed above. Not sure if this is the correct manual, but may be close. Page 3 and 4.

Tenda Wireless Router Setup on this page. Nov 27, 2017 . I had the same problem and, suspecting that the metal contacts weren't making proper contact with the batteries, I used a long nosed pliers to gently bend all ten contacts towards to the batteries (there are eight small tabs in the battery compartment, and two on the battery cover). If you don't have a long nosed pliers a small screwdriver should do it if you held the fixed part of each set of contacts so it doesn't detach during the process. Unfortunately, it worked, but only for one weigh, and then it reverted to 'Lo'. This happened twice, so I telephoned the Salter Customer Service Helpline (83) who recommended a reset, which is done by removing the batteries, standing on the scale for 20 seconds, and replacing the batteries. That also only worked for one weigh, so they are looking into it further and I'll post the results here, but in the meantime I hope one of the above solutions will work for others. Jan 21, 2014 .